Release Notes for -- Linksys PAP2T 3.1.15(LS)

PAP2T -- 2 Port FXS, 1 Ethernet Interface

Copyright (C) 2006 by Linksys, a Division of Cisco Systems, Inc.

All Rights Reserved.

* * * * * * * * * * IMPORTANT * * * * * * * * * * * * * * * *  *
* Use of Proprietary Information and Copyright Notice:         *
* This release note document contains proprietary information  *
* that is to be used only by Cisco/Linksys customers.          *
* Any unauthorized disclosure, copying, distribution, or use   *
* of this information is prohibited. This restriction includes *
* ALL Internet based discussion forums, e.g. DSLreports.       *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *  *

========================================
	Bug Fixes since 3.1.12(LS)
========================================
. Device will not accept a new INVITE that replaces another active 
  call-leg when it acts as the target of call transfer operation, if
  DND is enabled or any other call rejection/forward criteria matches this
  new INVITE. Hence the call transfer operation will fail.
   
. Restrict Source IP feature does not work when both DNS SRV and SRV Auto Prefix
  are enabled

. The Nonce count (nc) parameter in the SIP Authorization header 
  os not incremented when the phone sends out re-INVITE to hold/resume 
  inside a SIP dialog

. maddr parameter in first host of a record-route header is ignored
  if it is specified as FQDN instead of an IP address
   
. Show <DTMF Process AVT> and <DTMF Process INFO> options on configuration
  web page

. Change default <Ring Waveform> to "trapezoid", <Ring Frequency> to 20 Hz, and 
  <Ring Voltage> to 85V           

. Device should cold reboot automatically after resync if Primary or 
  Seconday DNS params has changed

=====================================================
	Feature Enhancements since 3.1.12(LS)
=====================================================
. Added <RFC 2543 Call Hold> config option. Default is yes.
  If set to "yes", unit will include c=0.0.0.0 syntax in SDP when reINVITE to 
  hold. If set to "no", unit will not include c=0.0.0.0. syntax in SDP when 
  reINVITE to hold. It will always include a=sendonly syntax when reINVITE to
  hold




